Site icon Garage Works Limited

How to Change Your Oil: A Detailed Step-by-Step Guide for People Who Don’t Like This Stuff

how to change your vehicle oil

Changing your oil might seem intimidating if you’ve never worked with your hands or done any car maintenance before. But don’t worry — with this comprehensive guide, you’ll be equipped with everything you need to change your oil confidently.

What You’ll Need:

  1. New Engine Oil: Check your car’s manual for the recommended type (e.g., 5W-30, 10W-40). Make sure it’s the right amount; typically, 4-5 quarts for most vehicles. Get your oil here.
  2. New Oil Filter: Ensure it matches the specifications of your car model.
  3. Oil Drain Pan: This is essential for collecting the old oil.
  4. Wrench or Oil Filter Tool: To remove the drain plug and the old oil filter.
  5. Funnel: To make pouring new oil easier.
  6. Rags or Paper Towels: For cleaning up any spills or drips.
  7. Rubber Gloves: To keep your hands clean and protect against oil residue.
  8. Car Jack & Jack Stands: Safety first! Use these to raise your car securely, or use a car ramp.
  9. Wheel Wedges: To prevent the car from rolling while it’s lifted.

Step-by-Step Guide:

1. Park Your Car on a Level Surface

Make sure your car is parked on flat, solid ground. Engage the parking brake, and if you’re working on an automatic transmission, make sure it’s in “Park.”

2. Gather Your Tools and Supplies

Before you begin, make sure everything you need is within reach. This prevents unnecessary trips to the store or garage.

3. Raise Your Car (If Necessary)

Use the car jack to lift your vehicle off the ground and set up your jack stands securely. If you’re using a car ramp, drive your car up the ramp and make sure it’s stable. Always use wheel wedges behind the tires to prevent any accidental rolling.

4. Locate the Drain Plug and Oil Filter

Open your car’s hood and identify the engine area. The drain plug is usually located at the lowest point of the oil pan (under the car), and the oil filter is typically found on the side of the engine block. Consult your car’s manual if you’re having trouble locating them.

5. Place the Oil Drain Pan

Position the oil drain pan directly underneath the drain plug to catch the old oil. Make sure it’s centered to avoid spills.

6. Drain the Old Oil

Using your wrench, carefully unscrew the drain plug by turning it counterclockwise. Be ready for the oil to start flowing immediately. Let the oil drain completely, which usually takes 5-10 minutes. Be patient, as this ensures all the old oil is removed.

7. Remove the Old Oil Filter

While the oil is draining, use an oil filter tool or your hand (with a rag for grip) to unscrew the oil filter. Some oil may still drain out when you remove the filter, so keep your oil drain pan positioned underneath. Make sure to wipe any excess oil from the engine area once it’s removed.

8. Prepare the New Oil Filter

Before installing the new oil filter, apply a bit of new oil to the rubber seal on the top of the filter. This helps create a secure seal and makes it easier to remove later.

9. Install the New Oil Filter

Screw the new oil filter into place by hand until it’s snug. Do not over-tighten, as this can damage the seal and lead to leaks.

10. Reinstall the Drain Plug

Put the drain plug back in and tighten it securely with your wrench. Be careful not to over-tighten, as this can strip the threads or damage the oil pan.

11. Add New Oil

Using your funnel, pour the new oil into the engine. Start with a small amount and check the level periodically using the dipstick (remove the dipstick, wipe it clean, reinsert, then remove again to check the oil level). Add oil until you reach the “Full” mark on the dipstick. Be cautious not to overfill, as too much oil can cause engine damage.

12. Check for Leaks

Start your car and let it run for a minute or two. Look under the car and around the oil filter for any signs of leaks. If you spot any, turn off the engine and make adjustments to the filter or plug as needed.

13. Lower Your Car

Carefully lower your car back to the ground using the jack and jack stands. If you used a ramp, slowly drive down the ramp with caution.

14. Dispose of Old Oil Properly

Take the old oil to an auto parts store, recycling center, or a facility that accepts used oil. Never pour oil down a drain or throw it in the trash; it’s harmful to the environment.

15. Clean Up

Wipe down any oil spills with rags or paper towels. Ensure your workspace is clean and free from any oily residues.

Pro Tips for Millennials:

Final Thoughts:

Changing your oil is a skill that not only saves you money but also helps you better understand and care for your car. With a bit of practice, it’ll become a routine part of your car maintenance. As always, Garage Works keeps you in the know!

Share this content:

Exit mobile version